Edimax WAP1750 Manual do Utilizador descarregar pdf (Página 16)

AP Mode

III. Quick Setup

Your access point can be up and running in just a few minutes. This quick

installation guide will help to set up your access point in its default AP mode

and configure its basic settings. For use a Managed AP within an AP array no

settings are necessary. Configurations can be made from your Controller AP

(refer to Edimax Pro NMS).

III-1. Initial Setup

1. Connect the access point to a computer via Ethernet cable.

2. Connect the power adapter to the access point’s 12V DC port and plug the

power adapter into a power supply using the included cable.

3. Please wait a moment for the access point to start up. The access point is

ready when the LED is blue.

4. Set your computer’s IP address to 192.168.2.x where x is a number in the

range 3 – 100. If you are unsure how to do this, please refer to the user

manual for more information.

Please ensure there are no other active network connections on

your computer (disconnect Wi-Fi connections and Ethernet

cables).

5. Enter the access point’s default IP address 192.168.2.2 into the URL bar of

a web browser.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 231 232

Sem comentários

Edimax WAP1750 Manual do Utilizador Página 16