Edimax N-9210TX-64 Guia de Instalação

EW-7438RPn Quick Installation Guide 06-2012 / v1.2

9 6. iQ Setup will start detecting available Wi-Fi networks automatically. All detected Wi-Fi networks will be displayed in the list. Select the one

10 Note: The extender will be unable to connect to the Wi-Fi network if you enter the wrong password. If you do not know your Wi-Fi password, you may

11 12. You may test the connectivity of the Wi-Fi extender by connecting to it (select its SSID from your list of wireless networks, not the SSID of y

12 Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital

13 EU Declaration of Conformity English: This equipment is in compliance with the essential requirements and other relevant provisions of Directive

14 Declaration of Conformity We, Edimax Technology Co., Ltd., declare under our sole responsibility, that the equipment described below complies wi

15 Notice According to GNU General Public License Version 2 This product includes software that is subject to the GNU General Public License version

16 intact all the notices that refer to this License and to the absence of any warranty; and give any other recipients of the Program a copy of this L

17 6. Each time you redistribute the Program (or any work based on the Program), the recipient automatically receives a license from the original lic

18

1 PRODUCT INTRODUCTION Package Contents Before you start using this product, please check if there is anything missing in the package, and contact y

2 Power On Device switched on and correctly powered Flashing Resetting to factory defaults Off Device not powered, not correctly powered, or in LED o

3 1. Plug the Wi-Fi extender into a power outlet close to the root wireless access point and switch it on (1). The extender will automatically initia

4 Note: Some wireless routers may reboot if the WPS button is held down for too long. To prevent accidentally rebooting your router, please refer to

5 root wireless access point) and attempting to open a web page with your web browser. 6. After you have connected the extender to the existing Wi-Fi

6 3. There are two ways to connect to the Wi-Fi extender. The first is a wired connection, using an Ethernet cable (i). The second is to connect wirel

7 If you have accidentally clicked “OK”, you will see the following. Please click “Cancel”. 4. Now you should be connected to the Wi-Fi extender

8 Method 2: Enter the extender’s default IP address (192.168.2.2) into your browser’s address bar. (Windows, Macintosh, and Linux) 5. You wil