Edimax Print Server Manual do Utilizador descarregar pdf (Página 88)

The PrintSir can be configured as DHCP server to

provide dynamic IP addresses assignment. The DHCP Cfg

page allows you to set:

z The DHCP startup, which determine if the PrintSir

will act as DHCP server. If this item is set to Auto,

the PrintSir will detect if there is any DHCP server

on the network when it boots up. If there is no

DHCP server on the network, then the PrintSir will

configure itself as DHCP server; otherwise it will

disable this function.

z DHCP setup is used to configure TCP/IP

parameters that will be assigned to a DHCP client.

If this item is set to Auto, the PrintSir will

determine all TCP/IP parameters automatically;

otherwise you will configure the following

parameters:

z IP Address: specifies the IP address of PrintSir

itself.

z Starting IP: specifies the starting IP address for

assigning to DHCP clients.

1 2 ... 83 84 85 86 87 88 89 90 91 92 93 ... 110 111

Sem comentários

Edimax Print Server Manual do Utilizador Página 88