Edimax WP-S1100 Manual do Utilizador descarregar pdf (Página 23)

Chapter II Using Projector Server

2-1 Switch the Projector Server On and Check IP address

When the connection between projector server and external display is

established, you can switch the display’s power on, then press the ‘Power’

button of projector server, which is located at the front of projector server.

You should be able to see the following image displayed on external display; if

not, please make sure the external display you used with projector server

accepts input video resolution ‘1024 x 768’, and horizontal refresh rate ‘60Hz’.

If you see above image shown on display for more than two minutes, please

press ‘Power’ button to switch the projector server off, and then switch the

projector server on again. If this still happens, refer to chapter 4-2

‘Troubleshooting’ for possible solutions.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 87 88

Sem comentários

Edimax WP-S1100 Manual do Utilizador Página 23