Edimax AC-M1000 Manual do Utilizador descarregar pdf (Página 12)

Compliance Certification Services Inc.

Report No.: 70125004-D Date of Issue: January 29, 2007

Page 12 Rev. 00

Procedure of Final Test

 EUT and support equipment were set up on the test bench as per step 10 of the preliminary

test.

 A scan was taken on both power lines, Line 1 and Line 2, recording at least the six highest

emissions. Emission frequency and amplitude were recorded into a computer in which

correction factors were used to calculate the emission level and compare reading to the

applicable limit. If EUT emission level was less –2dB to the AV. limit in Q.P. mode, then

the emission signal was re-checked using an AV. detector.

 The test data of the worst-case condition(s) was recorded.

Data Sample:

Frequency

(MHz)

QuasiPeak

reading

(dBuV)

Average

reading

(dBuV)

Correctrion

factor

(dB)

QuasiPeak

result

(dBuV)

Average

result

(dBuV)

QuasiPeak.

limit

(dBuV)

Average

limit

(dBuV)

QuasiPeak

margin

(dB)

Average

margin

(dB)

Remark

x.xx 43.95 33 10.0 53.95 43 56.00 46.00 -2.05 -3 Pass

Frequency (MHz) = Emission frequency in MHz

Reading (dBuV) = Uncorrected Analyzer/Receiver reading + Insertion loss of LISN, if it > 0.5 dB

Correction Factor (dB) = Antenna factor + Cable loss – Amplifier gain

Result (dBuV) = Raw reading converted to dBuV and CF added

Limit (dBuV) = Limit stated in standard

Margin (dB) = Result (dBuV) – Limit (dBuV)

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 21 22

Comentários a estes Manuais

Sem comentários

Edimax AC-M1000 Manual do Utilizador Página 12

Comentários a estes Manuais

Manuais e produtos relacionados com Redes Edimax AC-M1000